44
Tom Jones
0987654321
F
=Edit
H
=Save
Tom Jones
0987654321
Using the Directory
1
Press (FUNCTION/EXIT/CH).
2
While the arrow points to “Save
directory”, press
FWD/EDIT á (Yes key).
•The display shows the number of stored items
in the directory.
3
Enter a name, up to 15 characters using
the dialing buttons (p. 45).
•To move the cursor, press BACK Ü or
FWD/EDIT á.
•If a name is not required, press Ö (Next key)
and go to step 5.
4
Press Ö (Next key).
5
Enter a phone number, up to 22 digits.
•If you misdial, press (INTERCOM/CLEAR).
Digits are erased from the right. To erase all
digits, press and hold (INTERCOM/CLEAR).
6
Press Ö (Next key).
•If you want to change the storing name or
number, press Ñ (Edit key) repeatedly to
reach the desired display and change it.
7
Press FWD/EDIT á (Save key).
•A beep sounds.
•
To continue storing other items, repeat from step 2.
•To return to the standby mode, press
(FUNCTION/EXIT/CH).
•If a pause is required for dialing, (REDIAL/PAUSE) can be stored in a phone
number in step 5. This counts as one digit (p. 54).
•You can exit the programming mode any time by pressing (FUNCTION/EXIT/CH).
•If the display shows “Directory full” in step 2, press (FUNCTION/EXIT/CH).
To erase other stored items from the directory, see page 51.
•
After the maximum of 50 items has been stored, “Directory full” is also displayed.
•If 3 beeps sound and the display shows “Save error”, move closer to the base
unit and start again from step 1.
H
Save directory
Ringer volume
GF H
=Yes
Directory=
20 items
Enter name
IH G
=Next
Enter name
Tom Jones
IH G
=Next
Enter phone no.
0987654321
IH G
=Next
To Next Page
Loading...
