Direct Commands
74
During programming:
When “ ” or “ ” is displayed, press the right soft key to save the new
settings.
To exit programming, press [OFF].
• If you press the direct command incorrectly, press [OFF], then re-enter
programming mode by pressing [MENU].
• For function details, see the corresponding pages.
*
1
You need to first download melody data from the openLCR web site.
*
2
This feature can be used to activate Caller IQ. See the leaflet included with this
unit for more information.
*
3
For openLCR subscribers only.
*
4
For openLCR subscribers only. If information is not downloaded to your unit, “Get
new Info.?” will be displayed. To download information, see page 84.
*
5
After pressing
[7]
, make sure “
View Info.?
” is displayed, then press the next
command. If Caller IQ is turned off, “
Turn CIQ on?
” is displayed after pressing
[7]
.
Remote code [0] [6] [3] Go to Step 5 on page 66. –
Recording mode [0] [6] [4] [1] : Standard recording
[2] : Enhanced recording
p. 26
Mailbox 2&3
passwords
[0] [6] [5] Go to Step 5 on page 57. –
Change language [0] [8] [1] : English [2] : Spanish p. 17
Message alert [0] [#] [1] : On [0] : Off p. 26
Ringer tone
(Base unit)
[0] [*] [1] [1]–[3] : Tone pattern 1–3
[4]–[7] : Melody pattern 1–4
[8]–[9] : Downloaded melody
pattern 1–2 *
1
p. 21
Incoming call tone
(Base unit)
[0] [*] [2] [1] : On [2] : Twice [0] : Off p. 53
Handset registration [0] [0] Go to Step 4 on page 55. –
Talking Caller ID (Base unit)
[0] [*] [4] [1] : On [0] : Off p. 34
Menu item Command Selection items Page
SAVE
OK
To Next Page
Loading...
