Programming
26
For assistance, please visit http://www.panasonic.com/help
4 {V}/{^}: “Call block” i
{SELECT}
5 {V}/{^}: “Yes” i {SELECT}
i {OFF}
■ By entering phone numbers:
1 {MENU} i {#}{2}{1}{7} i
{ADD}
2 Enter the phone number (32
digits max.).
L To erase a digit, press
{CLEAR}.
3 {SAVE} i {OFF}
Block calls without phone number
You can reject a call without phone
number including “Out of area”,
“Private caller”, or “Long
distance”.
1 {MENU} i {#}{2}{4}{0}
2 {V}/{^}: Select the desired setting.
i {SAVE} i {OFF}
Viewing/editing/erasing call block
numbers
1 {MENU} i {#}{2}{1}{7}
2 {V}/{^}: Select the desired entry.
L To exit, press {OFF}.
3 Proceed with the desired operation.
■ Editing a number:
{EDIT} i Edit the phone
number. i {SAVE} i {OFF}
■ Erasing a number:
{ERASE} i {V}/{^}: “Yes”
i {SELECT} i {OFF}
Note:
L When editing, press the desired dial
key to add, {CLEAR} to erase.
L When viewing, {w/o NUM} appears if
the block calls without phone number
feature is turned on. To turn the
feature off: {w/o NUM} i {V} i
{SAVE} i {OFF}
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to
the base unit.
Important:
L See page 5 for information on the
available model.
Registering a handset to a
base unit
The supplied handset and base unit are
pre-registered. If for some reason the
handset is not re-registered to the base
unit, register the handset.
1 Handset:
{MENU} i {#}{1}{3}{0}
2 Base unit:
■ KX-TG6411 series: page 3
Press and hold {LOCATOR} for
about 4 seconds. (No registration
tone)
■ KX-TG6421 series: page 3
Press and hold {LOCATOR} for
about 4 seconds until the
registration tone sounds.
L If all registered handsets start
ringing, press the same button to
stop. Then repeat this step.
L The next step must be completed
within 90 seconds.
3 Handset:
Press {OK}, then wait until a long
beep sounds.
4 {OFF}
TG640x(e).book Page 26 Wednesday, November 26, 2008 2:33 PM
To Next Page
Loading...
