Error messages
Display message Cause/solution
Base no power
o
r
No link. Reconnect
AC adaptor.
or
No link.
R The handset has lost communication with the base unit. Move
closer to the base unit and try again.
R Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The handset’s registration may have been cancelled.
Re-register the handset (page 32).
R When “No link.” is displayed during a power failure, place
a handset on the base unit to supply power to the base unit.
Check Phone Line
R T
he supplied telephone line cord has not been connected yet
or not connected properly. Check the connections (page 10).
Error
R R
ecording was too short. Try again.
Memory Full
R T
he phonebook memory is full. Erase unwanted entries
(page 21).
R Message memory is full. Erase unwanted messages
(page 37, 38).
R The call barred list memory is full. Erase unwanted entries
(page 31).
Use rechargeable
b
attery.
R A wrong type of battery such as Alkaline or Manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 4, 7.
You must first
s
ubscribe to Caller
ID.
R You must subscribe to a Caller ID service. Once you receive
caller information after subscribing to a Caller ID service, this
message will not be displayed.
47
Useful Information
To Next Page
Loading...
