Panasonic KX-TG7200FX - Base Unit Settings

Base Unit Settings
19
Base unit settings
To customise the base unit using the handset:
1 {j/OK}
2 Press {^} or {V} to select “Base Unit Setup”. i {>}
3 Press {^} or {V} to select the desired item in the base unit settings menu. i
{>}
4 Press {^} or {V} to select the desired item in the sub-menu. i {>}
5 Press {^} or {V} to select the desired setting then press {>}.
L This step may vary depending on the feature being programmed.
L To exit the operation, press {ih}.
Note:
L The current item or setting is indicated by > on the display.
*1 KX-TG7220
*2 Change the recall time, if necessary, depending on the requirements of your
service provider/telephone company or PBX.
*3 When using the unit in Czech/Slovakia, select “100 msec.” as the recall time. If
you change the unit’s region setting/reset the base unit, the recall time will be reset
to the default setting. In this case, select “100 msec.” again.
*4 If you change the PIN, please make note of your new PIN. The unit will not reveal
the PIN to you.
*5 If you forget your PIN, consult your nearest Panasonic service centre.
Menu Sub-menu Details (default setting)
Ringer Volume
*1
— For base unit (Medium)
Call Options Dial Mode (“Tone”): page 12
Recall/Flash Recall time
*2
(“600 msec.”
*3
)
Other Options Base Unit PIN Change base unit PIN (“0000”).
*4
– Enter the current 4-digit base unit
PIN.
*5
– Enter the new 4-digit base unit
PIN. i {>} i {ih}
Repeater Mode (“Off”): page 34
Country Change the unit’s region setting
(“Other”): page 20
TG7200-7220FX(e-e).book Page 19 Friday, June 29, 2007 10:24 AM