Panasonic KX-TG7200FX - Receiving a Message

SMS (Short Message Service)
25
4 {^}/{V}: Select the message. i
{j/OK}
5 {j/OK} i {^}/{V}: “Erase”
i {>}
L To erase all messages, select
“Erase All”. i {>}
6 {^}/{V}: “Yes” i {>} i {ih}
Receiving a message
When an SMS message is received:
– “Receiving SMS Message” is
displayed
– a tone is heard (if the handset ringer is
turned on)
– F is displayed
Reading a received message
1
{j/OK}
2 {^}/{V}: “SMS” i {>}
3 {^}/{V}: “Receive List” i {>}
4 {^}/{V}: Select a message.
L Messages which have already
been read are indicated by a “Q”,
even if they were read using
another handset.
5 Press {j /OK} to read the message
content.
Note:
L To call the message sender, press
{C} or {s}.
Replying to a message
1
While reading a received message,
press {j/OK}.
2 {^}/{V}: “Reply” i {>}
3 Enter a message (page 36). i
{j/OK}
4 Edit the destination phone number
and/or press {j/OK}.
5 Continue from step 6, “Writing and
sending a new message”, page 24.
Editing/forwarding a message
1
While reading a received message,
press {j/OK}.
2 {^}/{V}: “Edit Message” i {>}
3 Continue from step 4, “Writing and
sending a new message”, page 24.
Erasing received messages
1
While reading a received message,
press {j/OK}.
2 {^}/{V}: “Erase” i {>}
L To erase all messages, select
“Erase All”. i {>}
3 {^}/{V}: “Yes” i {>} i {ih}
Storing the sender’s number
in the handset phonebook
1
While reading a received message,
press {j/OK}.
2 {^}/{V}: “Add Phonebook” i
{>}
3 Continue from step 3, “Adding
entries”, page 15.
Editing the sender’s number
before calling back
1
While reading a received message,
press {j/OK}.
2 {^}/{V}: “Edit and Call” i
{>}
3 Edit the number. i {C}
TG7200-7220FX(e-e).book Page 25 Friday, June 29, 2007 10:24 AM