Panasonic KX-TM100B

| Remote Operation from a Touch Tone Phone
Direct Remote Operation
Once you have entered the remote code, you can also control your unit by
direct commands instead of using the voice menu. To end the remote
operation, hang up anytime.
Direct commands
NEW MESSAGE
PLAYBACK
(4]
•Only new messages are played back.
ALL MESSAGE .
PLAYBACK 1
(5;
•All messages are played back.
REPEAT ,
(During playback) 1
| «The current message is repeated.
SKIP j
(During playback) 1
©
•The current message is skipped.
The next message is played.
STOP •Operation is stopped temporarily.
•To resume operation, enter a direct
command within 15 seconds, or the voice
menu will start.
GREETING 1
MESSAGE
3
•A voice prompt and a long beep are heard.
RECORDING ^ ©After the beep, talk immediately for up to
RECORD 2 minutes.
•The recording is stopped.
•The recorded message is played.
ERASING A
SPECIFIC
MESSAGE
(During playback)
©®
1 «The current message is erased.
1 *A short beep will sound and the next
message will be played.
ERASING ALL ,
MESSAGES 1 ©©
1 •All recorded messages are erased.
1 »A long beep sounds. The unit will
announce “No messages” and will
automatically hang up.
22