Panasonic KX-TM100B

Before Requesting Help »
Problem
Remedy
The unit does not work.
•Check the settings (p. 6-12).
•Unplug the AC adaptor to reset.
Plug in, then try again.
You cannot program function
items, such as the dialing
mode.
• Do not pause for over 60 seconds
while programming.
While programming, a
telephone connected to a
same line starts to ring and
stops the program.
•To answer the call, lift the handset.
Start from the beginning after hanging
up.
During message playback or
monitoring a call, no sounds
are heard.
•Press VOLUME Q to increase
volume.
The answering system is on,
but incoming messages are
not recorded.
• Memory is full. Erase some or all of
the messages (p. 16).
“ E20” is displayed, the
ANSWER indicator flashes
rapidly, and no new
messages are recorded.
•Memory is full. Erase some or all of
the messages (p. 16).
You cannot operate the «Be sure to enter the correct remote
answering system from a code.
touch tone phone. *The answering system may not
respond if the tones are too short to
activate the unit. Press each button
firmly.
•The answering system is off. Turn it
on (p. 13).
25