Panasonic KX-TVM50 - Remote Call Forwarding Set

3.2 Message Manager's Guide
100 Feature Manual
3.2.7 Remote Call Forwarding Set
The Message Manager can programme his or her extension from a remote location to forward various
types of calls to the desired extension or an outside telephone. There are 6 forwarding settings
available:
• FWD All—Forwards all incoming calls to a specified extension number.
• FWD Busy—Forwards all incoming calls to a specified extension number when the line is busy.
• FWD No Answer—Forwards all incoming calls to a specified extension number when there is no
answer.
• FWD Busy or No Answer—Forwards all incoming calls to a specified extension number when the
line is busy or there is no answer.
• FWD to CO—Forwards all incoming calls to telephone number 1 or 2 (preprogrammed in the
Mailbox Setting), or to any other telephone number.
• FWD Cancel—Cancels the forwarding setting.
Note
• The Remote Call Forwarding Set feature is only available when the VPS is connected to a
Panasonic KX-T series PBX using DPT Integration.
• By default, the extension number for the Message Manager's extension (assigned for
Operator 1 in the Day Mode) is "0". However, the default setting cannot be used with this
feature.
• FWD to CO must be enabled for the Class of Service (COS) assigned to the Message
Manager (see "Remote Call Forward to CO" in 2.2.2 Personal Options in Programming
Manual).
• FWD to CO must also be enabled in the COS setting in the PBX for the Message Manager.
Assigning Remote Call Forwarding Set
1. Log in to the Main Menu.
2. Press [6] to set Remote Call Forwarding.
3. Press [1], [2], [3], [4], [5], or [6] to select the desired forwarding setting.
• [1] FWD All
• [2] FWD Busy
• [3] FWD No Answer
• [4] FWD Busy or No Answer
• [5] FWD to CO—Go to Step 6.
• [6] FWD Cancel—Go to Step 9.