11. Using the Wi-Fi function
302
1 Connect to a smartphone. (P295)
2 Operate the smartphone.
•
The function can be assigned to the top, bottom,
left or right according to your preference.
You can send location information acquired with a smartphone to the camera. After
sending the information, you can also write it on images stored in the camera.
•
Once the location information is sent to the camera, you can also write it on images by
performing [Location Logging] (P270) in the [Playback] menu.
1 Start recording location information
2 Start recording images
3 Finish recording the location information
4 Sending and writing location information
•
Location information different from that at the time of recording may be written. Keep the
following points in mind:
– Set the camera’s [Home] setting in [World Time] to your region.
– Once you start recording location information with your smartphone, do not change the
camera’s [Home] setting in [World Time].
• Location information cannot be written on images that were recorded when the clock was not
set.
Sending images in the camera to an SNS
1 Select [ ].
•
You can switch the images to be
displayed by selecting the icon (
A
)
on the top left of the screen. To
display images stored in the camera,
select [LUMIX].
2 Touch and hold an image, and drag
it to send it to an SNS, etc.
•
The image is sent to a web service
such as an SNS.
Adding location information to images stored in the camera from a
smartphone/tablet
GPS
To Next Page
Loading...
Need help?
General
Weight and Dimensions
