11. Using the Wi-Fi function
314
1 Select the menu. (P63)
2 Select [Via Network] or [Direct], and connect. (P328)
3 Select the PC you want to connect to.
•
When the PC you want to connect to is not displayed, select [Manual Input], and enter the
computer name of the PC (NetBIOS name for Apple Mac computers).
4 Select the folder you want to send.
5 Check the send settings, and select [Set].
•
To change the send setting, press [DISP.]. (P336)
6 Take pictures.
•
To terminate the connection, follow the steps below:
> [Setup] > [Wi-Fi] > [Wi-Fi Function] > [Yes]
• You can terminate the connection or change the send settings by pressing [Wi-Fi]. (P292)
You cannot change the settings while sending pictures. Wait until sending is complete.
Sending an image each time a recording is made ([Send Images While
Recording])
> [Setup] > [Wi-Fi] > [Wi-Fi Function] > [New Connection] >
[Send Images While Recording] > [PC]
MENU
To Next Page
Loading...
