28
s Depending on the lens used, picture may be warped slightly or you may see colors along the
edge depending on the zoom factor, due to the characteristics of the lens. Also, the peripherals
of the image might look warped because the perspective is enhanced when the wide angle is
used. This is not a malfunction.
s Is the flash closed?
Slide the [ OPEN] lever to open the flash.
s The flash is activated 2 times. The interval between the first and second flash is longer when
Red-eye
reduction is set so the subject should not move until the second flash is activated.
s The LCD monitor turns off when [AUTO LCD OFF] is selected for the [ECONOMY] mode.
[This does not happen when using the AC adaptor.]
If the remaining battery power is low, it may take longer for the flash to be charged, and the
time during which the LCD monitor is turned off may become longer.
s It will switch to viewfinder display if there is hand or object near the eye sensor.
Adjust the brightness of the LCD monitor/viewfinder to a proper level.
s [POWER LCD] is activated.
s Does the picture appear on the Viewfinder?
Press [LVF/LCD] to switch to LCD monitor display.
s Is the LCD monitor switched off?
Switch the display by pressing [DISPLAY].
s Is the [EXPO. SETTINGS] set to [SWITCH BY PRESSING THE LVF/LCD BUTTON]?
s It is only displayed on the LCD monitor when the camera is connected to a PC or printer.
s This is not a malfunction.
These pixels do not affect the recorded pictures.
Lens
Recorded image may be warped, or nonexistent color is surrounding the
subject.
Flash
The flash is not activated.
The flash is activated 2 times.
LCD monitor/Viewfinder
The LCD monitor turns off although the camera is turned on.
The LCD monitor/Viewfinder is too bright or dark.
The picture is not displayed on the LCD monitor.
LCD monitor and viewfinder do not switch when [LVF/LCD] is pressed.
Black, red, blue and green dots appear on the LCD monitor.
s In dark places, noise may appear to maintain the brightness of the LCD monitor. This does not
affect the pictures you are recording.
s The LCD monitor may flicker for a few seconds after turning the camera on indoors under
fluorescent light. This is not a malfunction.
s This is characteristic of MOS sensors which serve as the camera’s pickup sensors.
This is not a malfunction.
s This is a characteristic of the drive system of the viewfinder of this unit, and it is not a
malfunction. The
re will be no problem with the recorded image.
Noise appears on the LCD monitor.
The LCD monitor flickers indoors.
AflickeringhorizontallineappearsontheLCDmonitorunderfluorescentlight.
You see red, green, or blue flashes when you move your eyes in the viewfinder,
or when the camera is moved rapidly.