137
6. Focus and Brightness (Exposure) Settings
• When the brightness is insufficient for [AFF] or [AFC], the camera will operate as if [AFS] has
been set. In this case, the display will change to the yellow [AFS].
Not available in these cases:
•
Depending on the lens used, [AFF] and [AFC] may not operate. Refer to the website on P19.
• When the interchangeable lens (H-H020A) is used, [AFF] and [AFC] cannot be set.
Changing the focus mode assigned to [AFS] of the focus mode lever
[MENU] > [Custom] > [AFS/AFF]
[AFS]: Assigns [AFS].
[AFF]: Assigns [AFF].
When recording using [AFF], [AFC]
•
It may take time to focus on the subject when you operate the zoom from Wide to Tele or
suddenly change the subject from a distant one to a nearby one.
• Press the shutter button halfway again when it is difficult to focus on the subject.
• While the shutter button is pressed halfway, shake may be seen on the screen.
• When AF Mode is set to [ ], the first AF area at which focus is achieved may be displayed
momentarily while pressing halfway.
• A beep will be emitted when focus is first achieved during the pressing halfway.
To Next Page
Loading...
