177
8. Functions Customised for Various Subjects and Purposes
3 Press 3/4 to select [Start] and then press [MENU/SET].
4 Press the shutter button fully.
•
The recording starts automatically.
• During recording standby, the power will turn off automatically if no operation is performed
for a certain period. The Time Lapse Shot is continued even with the power turned off.
When the recording start time arrives, the power turns on automatically.
To turn on the power manually, press the shutter button halfway.
• If [Fn1] is pressed or [ ] is touched while this unit is turned on, a selection screen
asking you to pause or end will be displayed. Operate in accordance with the screen.
Also, if [Fn1] is pressed or [ ] is touched during the pause, a selection screen asking
you to resume or end will be displayed. Pressing the shutter button fully will also enable
you to resume from the pause.
• This function is not for use in a security camera.
• If you leave the unit somewhere to perform [Time Lapse Shot], please be careful of theft.
• Recording for long periods in cold places such as ski resorts or places at high altitude,
or in warm, wet environments may cause a malfunction, so please be careful.
• Recording may not be consistent with the set recording interval or the set number of pictures
depending on recording conditions.
• We recommend that you use a sufficiently charged battery or an AC adaptor (optional) and a
DC coupler (optional).
• [Time Lapse Shot] is paused in the following cases.
– When the charge on the battery runs out
– Turning the camera off
During [Time Lapse Shot], you can replace the battery and the card, and then restart by turning
on this unit. (Note that pictures taken after the restart will be saved as a separate set of group
pictures) Turn off this unit when replacing the battery or the card.
• Do not connect the AV cable (optional), the HDMI micro cable, or the USB connection cable
(supplied) during Time Lapse Shooting.
• When only one picture is taken, it will not be saved as a group picture.
Not available in these cases:
•
This function is not available in the following cases:
– [Handheld Night Shot] (Scene Guide Mode)
– [Multi Exp.]
– When using [Stop Motion Animation]
To Next Page
Loading...
Need help?
General
Weight and Dimensions
