Panasonic LUMIX DMC-ZS100

98
SQW0547
Recording mode
Taking pictures after automatically setting the aperture value and shutter speed (Program AE Mode)
•
ZS100
The camera automatically removes noise when [Long Shtr NR] is set to [ON] and
the shutter speed is slow. Therefore, [Long shutter noise reduction ongoing] may
be displayed. (→144)
Although noise reduction requires the same time as the shutter speed for signal
processing, you can take sharp pictures.
•
ZS60
The camera automatically removes noise when the shutter speed is slow.
Therefore, [Long shutter noise reduction ongoing] may be displayed.
Although noise reduction requires the same time as the shutter speed for signal
processing, you can take sharp pictures.
Enabling/disabling the exposure meter display
→ [Custom] → [Expo.Meter] → [ON] / [OFF]
●
When you set this function to [ON], an exposure meter is
displayed during Program Shift, aperture setting, and shutter
speed operation.
●
Proper exposure is not possible in the range indicated in red.
●
If the exposure meter is not displayed, press the [DISP.]
button to switch the display of the monitor. (→53)
Exposure meter
250 125 60 30 15
5.64.02.8
60
p
●
The exposure meter will turn off if no operation is performed for approximately
4 seconds.