- 57 -
Using the [Setup] menu
Item Settings, notes
[Economy]
Turn off the power or
make the LCD monitor
go dark while not using
the camera to minimize
battery consumption.
[Sleep Mode]
[2MIN.] / [5MIN.] / [10MIN.] / [OFF]:
Automatically shut off power while not in use.
• To restore → Press the shutter button halfway, or turn on
the power again.
• Cannot be used in the following cases:
When connected to computer/printer, during motion
picture recording/playback, during Slide Shows, during
automatic demo playback
• Settings fixed to [5MIN.] in [Intelligent Auto] Mode.
[LCD Power Save]
[ON] / [OFF]:
The LCD monitor goes dark to minimize power
consumption.
• Reduces the picture quality of the LCD monitor display
during recording to minimize battery consumption
(except for the Digital Zoom area). Note, however, that
there is no effect on the recorded picture.
• The setting in [LCD Mode] is prioritized over the setting
in [LCD Power Save] for the brightness of the LCD
monitor.
[Auto Review]
Automatically display
still pictures immediately
after taking them.
[1SEC] / [2SEC]
[HOLD]: Auto review screen remains until a button (other
than the [DISP.] button) is pressed
[OFF]
• The following cases are fixed to the settings indicated
below.
[Intelligent Auto] Mode: [2SEC]
Scene Mode [Panorama Shot]: [2SEC]
• Automatically displays still pictures immediately after
they are taken regardless of the [Auto Review] setting in
[Auto Bracket], [Burst] mode, and [Handheld Night Shot]
and [HDR] Scene Modes.
• Motion pictures cannot be automatically reviewed.
• For details about the setting procedure in the [Setup] menu (→51)
To Next Page
Loading...
Need help?
General
