Panasonic MultiCam PV-DV202-K - Page 103

103
For Your Information
ZOOM-MIC (p. 21)
When set to ON, the microphone’s
directional angle and sensitivity vary
according to the zoom operation.
REMOTE (p. 10)ly
VCR1: To receive signals from the
Remote Control, set to VCR1.
VCR2: To receive signals from
the Remote Control, set to
VCR2.
OFF: To prevent reception of
signals from the Remote
Control.
BEEP
Set to ON to hear beep when starting
and stopping camera recording or
when unusual conditions occur. To
cancel the beep, set to OFF.
Palmcorder will beep:
Once when you start recording
Twice when you stop recording
Repeatedly when warning of
unusual conditions.
(pp. 99, 100)
MAGICVU (PV-DV402-K only)
(p. 25)
To select one of the 3 MagicVu
modes slide MAGICVU/0LUX Switch
to ON.
DISPLAY (p. 108)
To select the desired type of display
and counter indication displayed on
the LCD Monitor or in the viewfinder.
C.RESET (p. 108)
Setting to ON resets the counter to
zero.
DATE/TIME (p. 107)
The date and time can be set and
displayed on the screen.
CLOCK-SET (p. 16)
When set to ON, the date and time
can be set on the screen.
LCD/EVF SETTING (p. 19)
Setting to ON displays the menu for
adjusting the LCD brightness,
colour level, and the EVF brightness.
TITLE (p. 27)
Photo Title is recorded.
MODE (p. 27)
To select one of the 2 Photo Title
modes.
13
14
15
16
17
18
19
20
20
21
22
MENU OSD
21
13
14
15
16
17
18
19
22
12
12
DV202_402-K.p101-103.p65 2003/06/12, 10:15103