Panasonic MultiCam PV-DV202-K - Page 62

62
Running the PHOTOVU/
MPEG4 Movie Messenger
System*
Before you begin
• Insert a recorded tape. (p. 11)
* PHOTOVU: You can transfer Still images
from your Palmcorder tape to a PC.
MPEG4 Movie Messenger System:
You can transfer Motion images from your
Palmcorder tape to a PC.
1 Set Palmcorder POWER to VCR.
2 Connect the Palmcorder to your PC
using the USB Cable (supplied) or
DV Interface Cable (i.LINK) (not
supplied). (pp. 60, 61, 74)
3 Click on “Start,” “(All) Programs,”
“Panasonic,” “MPEG4
MovieMessenger System 1.00,” then
“MovieMessenger.”
4 “PHOTOVU/MPEG4 MovieMessenger
System 1.00” is opened.
Refer to Help on program for
information about application operations
and Error messages.
While PHOTOVU/MPEG4 Movie Messenger System is running,
do not perform the following operations...
The PC system may become unstable.
• Change the screen area or colour pallet in the Display Properties window.
• Turn the Palmcorder power switch ON or OFF while connecting the Palmcorder to your
PC using the USB Cable or DV Interface Cable (i.LINK).
• Change the Palmcorder power switch (VCR/CAMERA).
*You must first close the application.
• Connect/disconnect the DV Interface Cable (i.LINK).
• Connect/disconnect the USB Cable.
Note
PHOTOVU/MPEG4 Movie Messenger System
DV202_402-K.p 62-65.p65 2003/06/12, 10:1562