Panasonic Omnivision PV-V4640

*Important: If the remote control POWER, ACTION, PROG/ VCR+, CH4/¥, NUMBERED keys,
INPUT, SEARCH/ M/A SKIP or ADD/DLT button does not work when pressed, press
the VCR button on the remote and try the button again.
| Exit program mode.
le Press PROG/ VCR+
O KS (or ACTION).
Set timer.
Press POWER off. T } m A
+ When recording programs via a
cable box, make sure the cable
box is teft ON and tuned to the
desired channel.
You can also display Program screen from MENU
1) Press ACTION to display MENU.
* You can also set up using VCR buttons. See the bottom right of the page 16.
2) Press AV and P to select and set SET UP FEATURE.
3) Press AY to select TIMER PROGRAMMING and press > to
display Program screen.
4) Go to step 3 on the page 16.
Important notes when using a DSS receiver
* When recording programs via a DSS receiver, the DSS receiver must
be left on.
» When recording programs via an antenna or cable, the DSS receiver
must be turned off.
Review, Replace or Clear Program Contents: _
(Recording is not in progress)
a Repeat steps 1~2 on page 16.
Select program.
1) Press AY to
select number.
P DT START STOP CH SPD
1 DAY 9:00A12:004 08 SP
2 8 10:00P12:00P 02 SP
3 10 8:00P 9:00P 10 SP
4 SU 9:00P10:00P L1 LP
CANCEL : ADD/DLT KEY
SELECT 1-8:4 ¥ KEY
CG To Replace program...
RATE START _ STOP CH
Multi Function Display
|
SAT 10:00P 12:00P 02
DAY
CATEGORY :MOVIE
NOTES: STAND BY ME
SELECT START DATE
SELECT:4 ¥ KEY
SET 4 > KEY |
or
To Clear program...
P DT START STOP
2 8 10:00P 12:00P
3 10 8:00P 9:00P
4 SU 9:00P 10: 00P
SELECT 1-8:4 v KEY
ENTER ‘p> KEY
i | 1) Press P to display.
,| 2) Press AV <P to
“1 setnew program
contents,
1) Press ADD/DLT.
ADD/OLT
End the program.
1) Press
* |f there are programs, press
POWER off.
To cancel Timer Recording
(Recording is in progress)
Press POWER and then STOP
within 10 seconds to cancel the
Timer recording. (“TIMER” goes
out on Multi Function Display.)
To review program
contents on the VCR
Timer Recording is not in
progress
Press PROG/ VCR+ in Power off
mode.
Every time that button is pressed,
the program contents are
indicated in turn on the Multi
Function Display.
Timer Recording is in progress
Press PROG/ VCR+. The program
content which advances at
present is indicated on the Multi
Function Display.
Multi Function Display
Co)
© pp) SELECT/
(a) (Y SET
era A ¡PLAY
OA - Y STOP
SEE > 4 REW
(054) A > FF
LESS
D d
| PROG/
A VCR+
a % || œd action
Goo oi
SE Ss C ADD/
i DELETE
ROG/ VCR+ (or ACTION).
17
=
3
4]
=
me)
(D
©
e]
=
5
m}
(Q