Panasonic Omnivision PV-V4640

*Important: If the remote control POWER, ACTION, PROG/ VCR+, CHA/W, NUMBERED keys,
INPUT, SEARCH/ M/A SKIP or ADD/DLT button does not work when pressed, press
the VCR button on the remote and try the button again.
Auto VCR Plus+ System
Process of Recording
Channel Setup (Part 2) ‘Setup | =>
Before you perform the following steps, you should have:
«completed “Auto VCR Plus+ System Channel Setup
(Part 1)” on page 18.
eleft VCR off overnight, and turned it back on after 2 SELECT/
9:00 AM the next day. SET
A :PLAY
if channel updating, was lf VCR could not Y :STOP
successful...
distinguish
channel
map...
ee
VCR Plus+ CH SET UP VCR Plus+ CH SET UP
VCR Plus+ CH SET PLEASE SELECT
COMPLETED VCR Plus+ CHANNEL
1 ACTION
END
:ACTION
KEY
NEXT
:ACTION
KEY
s
Exit this mode. Display SELECT
| Press VCR Plus+ CH.
A ACTION. 1) Press
ACTION
O A to display. DELETE
2) Continue
with step 2.
SELECT VCA Plus+ CH Select channel map
KMEX KCAL KWHY KVCA > | for your area.
TEE
1) Press AV
d> to
select.
SELECT:
&
vr
KEY
:
END
ACTION
KEY
2)
Press
ADD/
DLT
to
set.
=!
3
®
om
J
M
O
Le)
-—
=
53
(Q
Cc
a
3
2
<
O
mo
Y
e
wo
+
Y)
<
YN
=
(D
3
To Change or Update Auto VCR
Plus+ System Channel Setup
VCR Plus+ CH SET UP End Setup. (E.g. you selected wrong channel map or
PLEASE LEAVE VCR OFF z KERA N zip code.)
(OVERNIGHT) pen A j a Do “Auto VCR Plus+ System Channel
O Setup (Part 1)” steps 1~4 on page 18.
VCR Plus+ CH SET UP
END :ACTION KEY * Make sure to leave VCR off
(overnight.) li controllable, UPDATE VCA Plus+ CH
leave your cable box on. SELECT VCR Plus+ CH
Channel map will be updated overnight. SELECT:A Y KEY
If it was successful, “VCR Plus+ CH SET COMPLETED” SET :» KEY
END ¡ACTION KEY
appears on screen. And then, press ACTION to exit.
bPress AV to select UPDATE VCR Plus+
or SELECT VCR Plus+ CH, then press P.
C If you selected UPDATE VCR Plus+ CH,
Repeatthese steps as necessary. perform steps 5-7 in the “Auto VCR Plus+
; System Channel Setup (Part 1)” section
if
Auto
Setup
fails,
do
“Manual
VCR
Plus+
System
pe
page
18.
eens
Channel Setup” on page 20. If you_selected SELECT VCR Plus+ CH,
` perform steps 2-3 in the “Auto VCR Plus+
System Channel Setup (Part 2)” section
on this page.
19