Panasonic Omnivision PV-V4640

Multi-Brand Control Feature
The Remote Control may be set up to control some TV or Cable/DSS Box functions.
Multi-Brand Control Setup
1 Find your TV, Cable or DSS Receiver Brand
Code Number on following page.
3 POWER
Setup for TV Setup remote. D Wor
Hoid down TV and enter code DSS/ CABLE
with NUMBERED keys.
Hold down DSS/CABLE and
enter code with NUMBERED keys. D NUMBERED
keys
* For code 100 or greater, press the
100 key first, then remaining digit.
E.g. for 102, pross 160, iben press O,
and then press 2.
Confirm code entry.
Press POWER to turn selected
unit on or off.
» See table below for list of
controllable functions in each mode.
( Notes } * Please repeat Multi-Brand Control setup after replacing remote
control batteries.
* The remote contro! will not operate all TVs, Cable Boxes, and
DSS receivers made by manufacturers listed. If you get no
results, your particular brand cannot be controlled.
į Using the Multi-Brand Control
` After remote contro! is setup, you can select VCR, TV, or DSS/CABLE for the desired function.
z= Press VCR or TV or DSS/CABLE on the remote control.
This table shows which buttons are available for each mode.
Available
Buttons VCR TV
Ali Functions VOL UP/DOWN
VCR/TV, PLAY, STOP
TV EJECT, SAP/Hi-Fi, POWER, INPUT,
DISPLAY, FF, REW, NUMBERED keys,
PAUSE/SLOW, REC,
SPEED, COUNTER RESET CUE pot DOWN,
TAPE POSITION, C/A SKIP
CABLE/ DSS VOL UP/ DOWN
Note | In TV or DSS/ CABLE mode, it may be necessary to press ENTER after pressing NUMBERED keys for channel selection.
CABLE/ DSS
VCR/TV, PLAY, STOP
EJECT, SAP/Hi-Fi,
DISPLAY,FF, REW,
PAUSE/SLOW, REC,
SPEED, COUNTER RESET
TAPE POSITION, C/A SKIP
POWER, ENTER,
NUMBERED keys
(except 100key),
CH UP/ DOWN
22 For assistance, call 1-800-211-PANA(7262).