Panasonic Omnivision PV-V4640

Timer Recording Using VCR Plus+° System (continued)
Manual VCR Plus+ System Process of Recording
Channel
Setup
019]
<>
[Programming]
* Before you begin, complete “Channel Setup
Preparations” below right.
Important Note
* If your VCR connection type changes from type A to B, on
page 6, perform “To Setup VCR in Case a Cable Box or DSS 2 SELECT/
Receiver was Installed or Replaced” section on page 10 7 SE
before
proceeding
with
these
steps.
å
PLAY
Do “Auto VCR Plus+ System Channel As
Setup (Part 1),” steps 1~3 on page 18. > :FF
VCR Pluss CH SET up.) Select MANUAL SET. 4 action
. ‘| 1) Press AV
MALCAL SET ets
2) Press >
SELECT:A ¥ K to set. ENT 3 ae
: EY ane ES, on | DELETE
SET :m KEY
END ¡ACTION KEY 3 Y E Si
la am”
IMPORTANT NOTE:
For step 3, use the list you prepared. You may leave lines
blank if you don't receive that station, or if the GUIDE CH
number and the RECEIVE CH numbers are the same.
VCR Plus+ CH SET UP shah VCR Plus+
channels.
GUIDE CH RECEIVE CH
1) Press ®
> Πto move
cursor to
SELECT :4 Y KEY j
SET :» KEY right
END :ACTION KEY column.
2) Press AW to change
VCR Plus+ CH SET UP RECEIVE CH number. Channel Setup Preparations
in order to complete step 3 left, make a
GUIDE cH Receive ch | 3) Press to set. local channel list (see example below).
- “> 01 4) Press AY to scroll You will need the following:
02 up/down GUIDE CH + A line up of normal TV and/ or Cable or DSS
de SELECT: A Y KEY column, (when DSS receiver is connected only.) stations
SET :4 KEY anenai and the channel number you receive them on.
END - (ACTION KEY e Repeat step 3 until list is * A list of Guide (PlusCode) channel numbers for
complete. the stations you receive found in TV Guide and
selected newspapers.
1 Make a 3-column chart. In the left column, write
the name of all the stations you receive.
2 In the middle column, write each station's Guide
(PlusCode) number from TV Guide.
Ar a ee setup. 3 In thei fight column, write the channel number
our receives the station on.
Press ACTION j
three times. EXAMPLE ONLY
Broadcast or Assigned | Channel no.
Guide your TV
Cable (PlusCode) | receives the
Station Name | channel no. | station on
To make corrections,
Press AV and > to move to error, then AV to change,
or ADD/DLT* to erase number,
«x each entry within 5 minutes or the VCR will exit this mode.
Once local channels have been programmed, they will stay in
memory, even in the case of a power failure. -
Nickelodeon | 38 | 2 |
VCR Plus+, C3, ALLSET, and PlusCode are trademarks CBS
of Gemstar Development Corporation. The VCR Plus+
system is manufactured under license from Gemstar Nox ë | n | = O
Development Corporation.
20 For assistance, call 1-800-211-PANA(7262).