Panasonic Omnivision PV-V4640

Timer Recording Using VCR Plus+° System
VCR Plus+ System is ...
a feature that allows you to set most items
of a timer recording by simply entering a
special code number (PlusCode
programming number) found in TV GUIDE
and selected newspaper TV listings.
Auto VCR Plus+ System
Channel Setup (Part 1)
In order for VCR to read PlusCode, some set up is required. Guide (VCR
ci channel number is assigned to each local broadcast and cable station.
ecause this number sometimes differs from channel TV receives station on, .
it is necessary to program the VCR with local channel information. To receive Process of Recording
VCR Plus+ channels automatically, perform the steps below. > —
Or, see “Manual VCR Plus+ System Channel Setup” section on page 20. ;
ee:
2
MENU
SET UP VCA
SET UP FEATURE
SET CLOCK
SET UP CHANNEL
1DIOMA/ LANGUE: ENGLISH
-VCRS OUTPUT CH:3
SELECI & Y KEY
SET :» KEY
SET UP CHANNEL
ANTENNA : CABLE
AUTO SET
CHANNEL CAPTION
WEAK SIGNAL DISPLAY : OFF
CABLE/DSS BOX SET UP
VCR Plus+ CH SET UP
SELECT :4 ¥ KEY
SET :» KEY
END ACTION KEY
VCR Plus+ CH SET UP
AUTO SET
MANUAL SET
SELECT:4 Y KEY
SET :b KEY
VCR Plus+ CH SET UP
PLEASE ENTER ZIP CODE
ZIP CODE: B----
SELECT:A Y KEY
SET ¿> KEY
END ¿ACTION KEY
PLEASE SELECT HOW OFTEN
TO UPDATE
RIGHT NOW
EVERY NIGHT
EVERY MONDAY NIGHT
VCR Plus+ CH SET UP
PLEASE LEAVE VCR OFF
AND CABLE BOX ON
(OVERNIGHT)
END ¡ACTION KEY
-JL E
Display MENU.
Press ACTION.*
Display SET UP CHANNEL.
1) Press AV to
select.
> “| 2) Press P to
rin
display.
Display VCR Plus+ CH
SET UP.
1) Press AY to
select.
2) Press > to
display.
Select AUTO SET.
1) Press AY to
select.
Enter Zip Code.
1) Press AV 4>
to select and
enter each
number.
2) Press ® or
Select When to Update.
1) Press AY to
End setup.
A Press ACTION.
* Make sure to leave VCR off
(overnight.) If controllable, leave
your cable box on.
2) Press > to set.
ACTION to set.
: ; select.
ie le 2) Press P to set.
important Note
¢ “One Time VCR Setup” on pages6~11 must
be completed before “Auto VCR Plus+
System Channel Setup” can be done.
lf any part of setup is incomplete,
a warning screen appears.
¢ If your VCR connection type changes
from type A to B, on page 6, perform
“To Setup VCR in Case a Cable Box or
DSS Receiver was Installed or
Replaced” section on page 10 before
proceeding with these steps.
+ Complete this page only if type B
connection (see page 6.) is used.
2 SELECT/
* Make each entry within 5 minutes or VCR will
leave this mode.
* Once local channels have been
programmed, they will stay in memory, even
in the case of a power failure.
+ “ALL SET” will flash on Multi Function Display
during Auto VCR Plus+ System Setup.
e If the start time for a timer recording comes
up during Auto VCR Plus+ System Setup, the
timer recording will have priority.
For assistance, call 1-800-211-PANA(7262).