Panasonic PT-DW530E

PROJECTOR SETUP menu
66
- ENGLISH
Settings
Press ▲▼ to select [TIME] or 4 )
[COMMAND] and change the setting
according to the instructions of the
menu.
TIME
Set the time at which the command
will be executed using ▲▼ buttons.
COMMAND
Select a command to execute at the
set time from the following.
POWER ON
•
STANDBY
•
AV MUTE ON
•
AV MUTE OFF
•
INPUT RGB1
•
INPUT RGB2
•
INPUT VIDEO
•
INPUT S-VIDEO
•
INPUT DVI-D
•
INPUT HDMI
•
INPUT
•
NETWORK
LAMP POWER
•
NORMAL
LAMP POWER
•
ECO
SIDE BY SIDE
•
MODE OFF
SIDE BY SIDE
•
MODE1
SIDE BY SIDE
•
MODE2
SIDE BY SIDE
•
MODE3
SIDE BY SIDE
•
MODE4
IN STANDBY
•
MODE (AUDIO)
ON
IN STANDBY
•
MODE (AUDIO)
OFF
VOLUME
•
Press ▲▼ to select [STORE] and 5 )
press <ENTER> button.
Note
If you try to register a setting that would cause the lamp to
z
ash for a short time, an error message will be displayed on
the screen. Set the [TIME] and [COMMAND] again.
To delete a command which has been set, press
z
<DEFAULT> button.
If multiple commands have been set for the same time,
z
they are executed in chronological order starting from the
smallest command number.
The setting time operates under the local time.
z
(
Æ
page 68)
If an operation is executed with the remote control or
z
control panel of the projector or with a control command
before the command set in the schedule is executed, the
command set with this function may not be executed.
RS-232C
This sets the communication parameters at the serial
terminals.
Press ▲▼ to select [RS-232C].1 )
Press <ENTER> button.2 )
The [
z
RS-232C] screen will be displayed.
Press ▲▼ to select communication 3 )
conditions.
press ◄► to change the setting.4 )
Note
Refer to
z
“Serial terminal” (
Æ
page 83).
J
Selecting items in [EMULATE]
When using the control commands for one of our
projectors that you have previously purchased to
control this projector using a computer via its serial
input terminal, set up the EMULATE function as
follows. This will allow you to use the control software
etc. designed for our existing projectors.
Select [EMULATE] in step 3).1.
Press <ENTER> button.2.
Press ▲▼ to select the required item.3.
Press <ENTER> button.4.
● DEFAULT
DZ570 Series, DW530 Series,
DX500 Series
L730
SERIES
L520 Series, L720 Series,
L730 Series
L780
SERIES
L750 Series, L780 Series
L735
SERIES
L735 Series
L785
SERIES
L785 Series
F SERIES
F100 Series, FW100 Series,
F200 Series, F300 Series,
FW300 Series
LB SERIES
LB75 Series, LB78 Series,
LB80 Series, LB90 Series,
LB1 Series, LB2 Series,
ST10 Series