Panasonic PT-DW530E - Troubleshooting

ENGLISH -
81
Maintenance
Troubleshooting
Should any problem persist, contact your dealer.
Problem Cause
Reference
page
Power does not turn
on.
The power cord may not be connected.
z
—
The <MAIN POWER> switch is turned off.
z
34
No electric supply is at the wall outlet.
z
—
The circuit breakers have tripped.
z
—
[LAMP indicator] or [TEMP indicator]is lit or ashes.
z
76, 77
The lamp unit cover has not been securely installed.
z
79
No picture appears.
The video signal input source may not be connected to a terminal
z
properly.
29
The input selection setting may not be correct.
z
37
The [BRIGHTNESS] adjustment setting may be at the minimum setting.
z
44
The input source which is connected to the projector may have a
z
problem.
—
The [AV MUTE] function may be in use.
z
37
If the [Power indicator] ashes in red, consult your dealer.
z
—
The picture is fuzzy.
The lens focus may not have been set correctly.
z
35
The projector may not be at the correct distance from the screen.
z
24
The lens may be dirty.
z
16
The projector may be tilted too much.
z
—
The color is pale or
grayish.
[COLOR] or [TINT] adjustment may be incorrect.
z
44
The input source which is connected to the projector may not be
z
adjusted correctly.
—
RGB cable is damaged.
z
—
The remote control
does not operate.
The batteries may be weak.
z
—
The batteries may not have been inserted correctly.
z
19
The remote control signal receptor on the projector may be obstructed.
z
19
The remote control unit may be out of the operation range.
z
19
Strong light such as uorescent shine onto the signal receptor.
z
19
[REMOTE CONTROLLER] of [CONTROL DEVICE SETUP] in
z
SECURITY menu is [DISABLE].
75
Is the remote (REMOTE IN) terminal used for external control?
z
86
The remote control ID setting is incorrect.
z
22, 63
The control buttons
of the projector do
not operate.
[CONTROL PANEL] of [CONTROL DEVICE SETUP] in SECURITY
z
menu is [DISABLE].
75
Is the remote (REMOTE IN) terminal used for external control?
z
86
The picture does not
display correctly.
[SYSTEM SELECTOR] may not have been set correctly.
z
47
There may be a problem with the VCR or other signal source.
z
—
A signal which is not compatible with the projector is being input.
z
88