Chapter 4 Settings — [PROJECTOR SETUP] menu
124 - ENGLISH
Note
f E-mail including the content of status can be sent to the E-mail addresses (up to two addresses) set in “[E-mail set up] page” (x page 153)
by pressing the <ENTER> button while displaying the [STATUS] screen.
f Some items in [SIGNAL INFORMATION] may be displayed and others not displayed, depending on the signal being input.
f If any abnormality has occurred on the projector, pressing the <DEFAULT> button while the [STATUS] screen is displayed shows the detail
screen of the error information.
f For details on the contents displayed in [SELF TEST], refer to “[SELF TEST] indications” (x page 171).
[NO SIGNAL SHUT-OFF]
A function that automatically switches the power source of the projector to standby if there is no input signal for a
certain period of time. The time before switching to standby can be set.
1) Press as to select [NO SIGNAL SHUT-OFF].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[DISABLE] Disables the No signal shut-off function.
[10MIN.] - [90MIN.] Sets the time in increments of 10 minutes.
[REMOTE2 MODE]
You can set the <REMOTE 2 IN> terminal.
1) Press as to select [REMOTE2 MODE].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[DEFAULT]
The pin assignment of the <REMOTE 2 IN> terminal is used by the factory default setting of the
projector.
[USER]
Used to change the setting of the <REMOTE 2 IN> terminal. (x page 184)
[L6500 SERIES] The setting of <REMOTE 2 IN> terminal is used for the L6500 series compatibility.
f When [USER] is selected, proceed to Step 3).
3) Press the <ENTER> button.
4) Press as to select one from [PIN2] to [PIN8], and press qw to switch the setting.
[FUNCTION BUTTON]
Set the functions of the <FUNCTION> button on the remote control.
1) Press as to select [FUNCTION BUTTON].
2) Press the <ENTER> button.
f The [FUNCTION BUTTON] screen is displayed.
3) Press as to select a function.
[DISABLE] Disables the <FUNCTION> button.
[P IN P]
Switches the [P IN P] setting to [OFF], [USER1], [USER2], or [USER3]. (x page 128)
[SUB MEMORY]
Displays the sub memory list. (x page 133)
[SYSTEM SELECTOR]
Switches the [SYSTEM SELECTOR] setting. (x page 81)
[SYSTEM DAYLIGHT VIEW]
Switches the [SYSTEM DAYLIGHT VIEW] setting. (x page 80)
[FREEZE]
Freezes the image temporarily. (x page 108)
[WAVEFORM MONITOR]
Displays the waveform of the input signal. (x page 108)
[ASPECT]
Switches the aspect setting. (x page 83)
4) Press the <ENTER> button.
[DATE AND TIME]
Set the time zone, date, and time of the built-in clock of the projector.
To Next Page
Loading...
