Panasonic PT-DX820

Chapter 3 Basic Operations — Operating with the remote control
ENGLISH - 67
Switching the input
The input for projection can be switched.
button
1) Press the input selection (<RGB1/2>, <DIGITAL LINK>, <DVI-D>, <VIDEO>, <SDI>, <HDMI>) button.
f This operation can be also performed using the buttons on the control panel.
<RGB1/2>
Switches the input to RGB1 or RGB2. Switches to the other input when one input has already been
chosen.
<DIGITAL LINK> Switches the input to DIGITAL LINK.
<DVI-D> Switches the input to DVI-D.
<VIDEO>
*1
Switches the input to RGB1.
<SDI>
*2
Switches the input to SDI.
<HDMI> Switches the input to HDMI.
*1 The operation is disabled in the factory default settings. The operation is enabled when [REMOTE CONTROL] is set to [USER] and [VIDEO
BUTTON] of [INPUT SELECT BUTTON] is set to other than [DISABLE], from the [SECURITY] menu → [CONTROL DEVICE SETUP].
*2 SDI input is supported only for PT-DZ780.
Note
f When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the <DIGITAL LINK/
LAN> terminal, the input on the DIGITAL LINK output supported device changes each time the <DIGITAL LINK> button is pressed. The input
can also be changed using the RS-232C control command.
For twisted-pair-cable transmitters of other manufacturers, switch the input on the projector to DIGITAL LINK, and then switch the input on
the twisted-pair-cable transmitter.
Using the Status function
You can display the status of the projector.
button
1) Press the <STATUS> button.
f The [STATUS] screen is displayed.
88h
70h/ ON/
70h/ ON/
1/5
1.00 / 1.00
26°C/78°F
32°C/89°F
42°C/107°F
1013hPa
MENU
EXITCHANGE
ENTER
SEND E-MAIL
SELF TEST
ATMOSPHERIC PRESSURE
AUTO - FLOOR
NO ERRORS
COOLING CONDITION
EXHAUST AIR TEMP.
OPTICS MODULE TEMP.
INTAKE AIR TEMP.
MAIN/SUB VERSION
LAMP1
PROJECTOR RUNTIME
PROJECTOR TYPE
DZ780(123456789012)
STATUS
LAMP2
Note
f This can be displayed from the [PROJECTOR SETUP] menu → [STATUS] (x page 122).