Chapter 3 Basic Operations — Switching on/off the projector
58 - ENGLISH
Initial setting (installation setting)
Set [PROJECTION METHOD] and [COOLING CONDITION] depending on the installation mode. Refer to
“Installation mode” (x page 31) for details.
After completed the initial setting, you can change the settings of each item from the [PROJECTOR SETUP]
menu.
1) Press as to select an item.
2/6
ENTER
SET
CHANGEMENU SELECT
It may shorten the life of the lamp and projector if used
in incorrect setting.
COOLING CONDITION
AUTO
When PROJECTION METHOD is changed, confirm that
COOLING CONDITION is set correctly.
PROJECTION METHOD
FRONT/FLOOR
INITIAL SETTING
2) Press qw to switch the setting.
3) Press the <ENTER> button to proceed to the initial setting.
Initial setting (standby mode)
Set the operation mode during standby. The factory default setting is [NORMAL], which allows you to use the
network function during standby. To keep power consumption low during standby, set this function to [ECO]. After
completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu → [STANDBY
MODE].
1) Press qw to switch the setting.
3/6
When set to ECO, network functions and SERIAL OUT
terminal, and some RS-232C commands are not
available during standby.
INITIAL SETTING
SET
CHANGE
STANDBY MODE
NORMAL
ENTER
2) Press the <ENTER> button to proceed to the initial setting.
Note
f The preceding initial setting screen is displayed when the projector is switched on for the rst time after purchase. If [ALL USER DATA] is
executed from the [PROJECTOR SETUP] menu → [INITIALIZE], the setting of [STANDBY MODE] set before execution is displayed.
To Next Page
Loading...
