Panasonic PT-DZ570U

PROJECTOR SETUP menu
68
- ENGLISH
Settings
J
Adjusting the date and time
automatically
Press ▲▼ to select [DATE AND TIME].1 )
Press <ENTER> button.2 )
Press ▲▼ to select [ADJUST CLOCK].3 )
Press <ENTER> button.4 )
The [ADJUST CLOCK] screen will be displayed.
z
Press ▲▼ to select [NTP 5 )
SYNCHRONIZATION] and press ◄► to
switch to [ON].
The setting will change as follows each time
z
◄► is pressed.
OFF ON
Press ▲▼ to select [APPLY], and 6 )
press <ENTER> button.
This completes setting of the time.
z
Note
To set the date and time automatically, the projector must
z
be connected to the network.
If synchronization with the NTP server fails just after
z
[NTP SYNCHRONIZATION] is turned [ON], or if [NTP
SYNCHRONIZATION] is turned [ON] while the NTP
server is not set, [NTP SYNCHRONIZATION] will return
to [OFF].
Access the projector via a web browser to set the NTP
z
server.
SAVE ALL USER DATA
This saves various setting values as a backup to the
internal memory of the projector.
Press ▲▼ to select [SAVE ALL USER 1 )
DATA].
Press <ENTER> button.2 )
The [SECURITY PASSWORD] screen will be
z
displayed.
Enter the password set for the 3 )
[SECURITY PASSWORD].
The conrmation screen will be displayed.
z
Press ◄► to select [OK], and press 4 )
<ENTER> button.
LOAD ALL USER DATA
This loads various setting values that were saved as a
backup to the internal memory of the projector.
Press ▲▼ to select [LOAD ALL USER 1 )
DATA].
Press <ENTER> button.2 )
The [SECURITY PASSWORD] screen will be
z
displayed.
Enter the password set for the 3 )
[SECURITY PASSWORD].
The conrmation screen will be displayed.
z
Press ◄► to select [OK], and press 4 )
<ENTER> button.
Note
If this is executed, the projector enters a standby state in
z
order to reect the setting values.