Cautions on Wireless LAN Module Installation
The optional Wireless LAN Module (part number ET-WM200U) is required to use
wireless LAN functions.
During installation, remove the cap from the Wireless LAN Module and mount the
module in the projector.
Procedure
Remove the setscrew of the Wireless 1 )
LAN Module cover, and remove this
cover from the projector.
Face the LED lamp of the Wireless LAN 2 )
Module upward, and insert the module
into the slot.
Close the Wireless LAN Module cover, 3 )
and secure it by tightening the Wireless
LAN Module cover xing screw.
Note
Keep the small parts out of the reach of small children.
z
Tighten screws using a torque screwdriver or others. Do not use an electric screwdriver or an impact
z
screwdriver.
The serial number of accessories and optional parts is subject to change without notice.
z
Wireless LAN Module cover
xing screw
Wireless LAN Module cover
LED lamp
To Next Page
Loading...
