Technical Information
Serial terminal
The serial connector which is on the connector panel of the projector conforms to the RS-232C interface
specication, so that the projector can be controlled by a personal computer which is connected to this connector.
J
Connection
J
Pin assignments and signal names
D-Sub 9-pin (female)
Outside view
Pin No. Signal name Contents
— NC
TXD Transmitted data
RXD Received data
— Connected internally
GND Earth
— NC
CTS
Connected internally
RTS
— NC
J
Communication conditions (Factory setting)
Signal level RS-232C-compliant Character length 8 bits
Sync. method Asynchronous Stop bit 1 bit
Baud rate 9 600 bps X parameter None
Parity None S parameter None
D-Sub 9-pin (male)
D-Sub 9-pin (female)
Connecting terminals
on projector
Communication cable
Computer
To Next Page
Loading...
