Troubleshooting
Error Error code
Error infomation
(See power failure detection system)
Error code
Error infomation
(
See power failure detection system
)
Normal 0 -
Power failure
1000 KS&DL, 1014 MAIN, S3.3V
1001 GAMMA, 3.3V 1015 MAIN, S5V
1002 GAMMA, 2.5V 1016 MAIN, S5VL
1003 GAMMA, 1.8V 1017 AUDIO&ID, 12V
1004 SH&PANEL, 15.5V 1018 SWFPGA, 1.2V
1005 HDMI, 5V 1019 FN901,
1006 HDMI, 3.3V 1020 FN902,
1007 HDMI, 1.2V 1021 FN903,
1008 ADC, 3.3V 1022 FN904,
1009 ADC, 1.8VD 1023 FN905,
1010 ADC, 1.8VA 1024 FN906,907,908,
1011 AV, S-6V 1025 FN909,910,911,
1012 LENS, 9V 1026 FILTER, DET
1013 LENS, 15V
Temperature Error
2000 Sensor A detects abnormal temperature. (IC1692-ROOM)
2001 Sensor A fails measurement. (IC1692)
2100 Sensor B detects abnormal temperature. (IC1816-LAMP)
2101 Sensor B fails measurement. (IC1816)
2102 Sensors B-A temperature error.
2200 Sensor C detects abnormal temperature. (IC1814-PANEL)
2201 Sensor C fails measurement. (IC1814)
2202 Sensors C-A temperature error.
Lamp Error
3000 Lamp1 fails on
3001 Lamp1 goes out
3002 Communication error on lamp1
System Error 4000
SWFPGA, ERROR
Shutter Error 5000
SHUTTER,ERROR
Filter Error 6000 Air filter unit
IRIS Error 7000 IRIS, ERROR
Error Log
This projector provides the error history log function. To
check the logs, you need to enter the service mode and se-
lect Group No. "220" and item No. "0" to "49". The error
code is displayed on the data column. The description of the
error code is listed on the table below.
* How to enter the service mode and select the group, item
and data value, see "Service Adjustment Menu Opera-
tion".
Group
No.
Item
No.
Data
(Error Code)
220 0
1
2
3
:
:
49
[
<- Latest Error
[
[
[
:
:
[
How to reset the Error Log
1. Enter the Service Mode, and select Group No. "220" and Item No. "50".
2 The history log will be reset when the data value is set to "10". The value automatically returns to "0".
* How to enter the service mode and select the group, item and data value, see "Service Adjustment Menu Operation".
To Next Page
Loading...
