Panasonic PT-EW630UL

-94-
Troubleshooting
If an indicator turns on
Ifaproblemoccurswithintheprojector,itwillbenotiedwiththetemperatureindicator<TEMP>,thelter
indicator <FILTER>, the shutter indicator <SHUTTER>*, and the lamp indicator <LAMP>.
Check the status of the indicators and take the following action.
CAUTION
ò Before you take a remedial measure, Turning off the projector.
ò If multiple indicators light or blink, verify the status of the projector by looking at each indicator.
Note
ò Conrmthestatusofthepowerindicatedonthe<ON(G)/STANDBY(R)>indicator.
When operating correctly

The status of the indicator is displayed with the following symbols.
p
:
Off
,
ò
:
On
,
★
:
Flashing
,
¢
:
Off or On or Flashing
Indicators
Status of the projector
<ON(G)/
STANDBY(R)>
Green/Red/
Orange
<TEMP>
Red
<FILTER>
Orange
<SHUTTER>
Blue
<LAMP>
Orange
p/p/p p p p p
The power plug has been removed from the out-
let.
p/ò/p
¢ *
1
¢ *
1
¢ *
1
¢ *
1
The projector is in the standby mode.
Turns on when pressing the <POWER ON> but-
ton on the remote control or the < > button on
the side control.
ò/p/p
¢ *
1
¢ *
1
¢ *
1
¢ *
1
The projector is operating normally.
p/p/★
*
2
¢ *
1
¢ *
1
¢ *
1
¢ *
1
The lamp is cooling down. The projector does not
turn on when pressing the <POWER ON> button
on the remote control or the < > button on the
side control until the standby indicator <ON(G)/
STANDBY(R)> changes to red.
★
*
2
/p/p
¢ *
1
¢ *
1
¢ *
1
¢ *
1
The projector is in the power management mode.
The lamp will turn on when controlling the projec-
tor, allowing the user to start operating it.
p/p/★
*
2
¢ *
1
¢ *
1
¢ *
1
¢ *
1
Power management mode is [On] and the lamp is
cooling down.
ò/p/p
¢ *
1
¢ *
1
ò
¢ *
1
The shutter function has been turned on.
Press any button on the remote control or the side
control to cancel the function.
p/ò/p
¢ *
1
¢ *
1
★
*
2
¢ *
1
The projector is in the shutter management mode.
The lamp will turn on when controlling the projec-
tor, allowing the user to start operating it.
p/p/
★
*
2
¢ *
1
¢ *
1
★
*
2
¢ *
1
Shutter management mode is [On] and the lamp
is cooling down.
*1: The indicator will change according to different conditions, regardless of the status of other indicators.
*2:Theindicatorwillashinapproximately1-secondintervals.