Standby Mode Notice
Function Normal Eco Network
Network
✔
--
✔
Serial command control
✔
--
✔
Monitor out
✔
-- --
Audio out
✔
-- --
RC sensor setting
✔ ✔
*1
✔
This projector provides 3 types of standby mode, Normal standby mode, Eco standby mode and Network standby
mode. According to the standby mode "Normal", "Eco" or "Network", several functions are restricted as shown in the
table below. To change the standby mode, use the projector's menu "Setting".
Normal ............ Normal standby mode.
Network .......... Supply the power to the network function even after turning off the projector. You can turn on /off
the projector via network, modify network environment, and receive an e-mail about projector status
while the projector is powered off.
Eco ................. Select "Eco" when you do not use the projector via network. The projector's network function will
stop when turning off the projector.
When "Eco" is selected, several functions will be restricted.
Restricted function in the standby mode
*1 When "Eco" is selected, all of the infrared remote receivers, top, front or rear are activated in the eco
standby mode regardless of the RC sensor setting.
To Next Page
Loading...
