Panasonic PT-EW630UL

-95-
Troubleshooting
When there is a problem with internal temperature

The status of the indicator is displayed with the following symbols.
p: Off, ò: On,
★
: Flashing, ¢: Off or On or Flashing
Indicators
Status of the projector
<ON(G)/
STANDBY(R)>
Green/Red/
Orange
<TEMP>
Red
<FILTER>
Orange
<SHUTTER>
Blue
<LAMP>
Orange
ò/p/p
★
*
1
¢ *
2
¢ *
2
¢ *
2
If the temperature within the projector becomes
too high, the temperature indicator <TEMP> will
start to flash slowly.
p/p/★
*
3
★
*
4
¢ *
2
¢ *
2
¢ *
2
If the temperature within the projector becomes
even higher, the temperature indicator <TEMP>
will flash faster, the power indicator <ON(G)/
STANDBY(R)> will turn off, and the projector will
turn off automatically.
The projector will not turn back on even when
pressing the <POWER ON> button on the re-
mote control or the < > button on the side
control. When the projector returns to the nor-
mal operating temperature, the standby indica-
tor <ON(G)/STANDBY(R)> will change to on.
The projector will turn back on when pressing
the <POWER ON> button on the remote control
or the < > button on the side control. (The
temperature indicator <TEMP> will remain flash-
ing.) Check the air filter.
p/ò/p
★
*
4
¢ *
1
¢ *
1
¢ *
1
The projector has cooled inside, and returned to
operating temperature. Pressing the <POWER
ON> button on the remote control or the < >
button on the side control will make the tempera-
ture indicator <TEMP> stop flashing and operate
the projector. Check the air filter.
*1:Theindicatorwillashinapproximately2-secondintervals.
*2: The indicator will change according to different conditions, regardless of the status of other indicators.
*3:Theindicatorwillashinapproximately1-secondintervals.
*4:Theindicatorwillashinapproximately0.5-secondintervals.