Panasonic PT-EW630UL

-96-
Troubleshooting
When there is a problem with internal power

The status of the indicator is displayed with the following symbols.
p: Off, ò: On,
★
: Flashing, ¢: Off or On or Flashing
Indicators
Status of the projector
<ON(G)/
STANDBY(R)>
Green/Red/
Orange
<TEMP>
Red
<FILTER>
Orange
<SHUTTER>
Blue
<LAMP>
Orange
p/p/
★
*
1
★
*
1
★
*
1
★
*
1
★
*
1
A problem has been detected within the projec-
tor.
The projector will not turn back on even when
pressing the <POWER ON> button on the re-
mote control or the < > button on the side
control. Remove the power plug from the outlet,
and plug it back in again.
If the power turns off, or the indicator turns on or
flashes again, remove the power plug from the
outlet and contact your dealer to request an in-
spection and repair. Do not leave the projector
plugged in with the indicator on or flashing. Doing
so may cause a fire or electric shock.
*1:Theindicatorwillashinapproximately0.5-secondintervals.
When there is a problem with the air filter

The status of the indicator is displayed with the following symbols.
p: Off, ò: On,
★
: Flashing, ¢: Off or On or Flashing
Indicators
Status of the projector
<ON(G)/
STANDBY(R)>
Green/Red/
Orange
<TEMP>
Red
<FILTER>
Orange
<SHUTTER>
Blue
<LAMP>
Orange
ò/ ¢
*
1
/ ¢
*
1
¢
*
1
ò
¢
*
1
¢
*
1
The indicator notifies you when the time set
with [Filter counter timer] has been reached.
Replace the air filter unit. (Filter replacement
icon will be shown at the top right of the screen
simultaneously.*
2
)
Alternatively, the indicator notifies you when
[Filter counter remaining] becomes 0%. Re-
place the air filter unit.
p/ò/p
★
*
2
★
*
2
★
*
2
★
*
2
When the air filter unit isn't installed, the pro-
jector is forced shutdown. Install the air lter
unit.
*1: The indicator will change according to different conditions, regardless of the status of other indicators.
*2:Theindicatorwillashinapproximately0.5-secondintervals.
*3: When [Display] is set to [On], the freeze function or shutter function will not be displayed on the screen during
operation.