Chapter 1
Preparation — About your projector
ENGLISH - 25
About your projector
Remote control
2
1
3
5
4 4
6
7
11
10
23
24
16
15
17
20
19
18
21
228
9
14
13
12
1 Power <v/b> button (v standby/b power on)
Sets the projector to the state where the projector is switched
off (standby mode) when the <MAIN POWER> switch on the
projector is set to <ON> and in the projection mode.
Also starts projection when the power is switched off (standby
mode).
2 Remote control indicator
Blinks if any button in the remote control is pressed.
3 <MENU> button/<RETURN> button/<ENTER> button/
asqw buttons
Used to navigate through the menu screen. (x page 57)
4 <VOL
-
> button/<VOL+> button
Adjusts the volume of the built-in speaker or audio output.
(x page 50)
5 <DEFAULT> button
Resets the content of the sub-menu to the factory default.
(x page 58)
6 Input selection (<COMPUTER1/2>, <DIGITAL LINK>,
<VIDEO>, <NETWORK>, <HDMI1>, <HDMI2>) buttons
Switches the input signal to project. (x page 47)
7 Number (<0> ~ <9>) buttons
Used for entering an ID number or a password in a multiple
projectors environment.
8 <ON SCREEN> button
Switches on (display)/off (hide) the on-screen display function.
(x page 51)
9 <ID ALL> button
Used to simultaneously control all the projectors with a
single remote control in a multiple projector environment.
(x page 55)
Automatically adjusts the image display position while the
image is projected. (x page 51)
11 <FUNCTION> button
Assigns a frequently used operation as a shortcut button.
(x page 54)
12 <TEST PATTERN> button
Displays the test pattern. (x page 54)
13 <ID SET> button
Sets the ID number of the remote control in a multiple projector
environment. (x page 55)
14 <ECO> button
Displays the setting screen relating to ECO management.
(x pages 55, 88)
15 <SCREEN ADJ> button
You can correct various types of distortion in a projected
image. (x page 52)
16 <FREEZE> button
Used when pausing the image and turning off the audio.
(x page 51)
Operates the presentation timer function. (x page 53)
18 <D.ZOOM -> button/<D.ZOOM +> button
Zoom in and out the images. (x pages 52, 86)
Used when temporarily turning off the video and the audio.
(x page 50)
20 <MUTE> button
Used when temporarily turning off the audio. (x page 50)
Switches the aspect ratio of the image. (x page 52)
22 <STATUS> button
Displays the projector information. (x pages 54, 87)
23 Remote control signal transmitter
24 This terminal is not used in this projector.
Front Top
Bottom
To Next Page
Loading...
