Panasonic PT-FZ570

Chapter 4 Settings — [DISPLAY OPTION] menu
78 - ENGLISH
Setting [COMPUTER1 EDID MODE]/[COMPUTER2 EDID MODE]
1) Press as to select [COMPUTER IN/OUT].
2) Press the <ENTER> button.
f
The [COMPUTER IN/OUT] screen is displayed.
3) Press as to select
[COMPUTER1 EDID MODE] or
[COMPUTER2 EDID MODE].
4) Press the <ENTER> button.
f
The
[COMPUTER1 EDID MODE] or the
[COMPUTER2 EDID MODE] screen is displayed.
5) Press qw to switch [EDID MODE].
f
The items will switch each time you press the button.
[DEFAULT] Standard setting.
[SCREEN FIT] Changes EDID data according to the [SCREEN FORMAT] setting.
[USER] Sets the [RESOLUTION] and [VERTICAL SCAN FREQUENCY] items to EDID.
f
When [DEFAULT] or [SCREEN FIT] is selected, proceed to Step 10).
6) Press the <ENTER> button.
f
The [RESOLUTION] screen is displayed.
7) Press as to select [RESOLUTION].
f
Select [1024x768p], [1280x720p], [1280x800p], [1280x1024p], [1366x768p], [1400x1050p], [1440x900p],
[1600x900p], [1600x1200p], [1680x1050p], [1920x1080p], [1920x1080i] or [1920x1200p].
8) Press the <ENTER> button.
f
The [VERTICAL SCAN FREQUENCY] screen is displayed.
9) Press qw to select [VERTICAL SCAN FREQUENCY].
f
Select [60Hz], [50Hz], [30Hz], [25Hz] or [24Hz] when [1920x1080p] is selected for [RESOLUTION].
f
Select [60Hz], [50Hz] or [48Hz] when [1920x1080i] is selected for [RESOLUTION].
f
The value is xed to [60Hz] when [1280x1024p], [1400x1050p], [1440x900p] or [1600x1200p] is selected
for [RESOLUTION].
f
Select [60Hz] or [50Hz] when anything other than the above signals are selected for [RESOLUTION].
10) Press the <ENTER> button.
f
The conrmation screen is displayed.
11) Press qw to select [OK], and press the <ENTER> button.
Note
f
The setting details are displayed in [RESOLUTION] and [VERTICAL SCAN FREQUENCY] below [EDID MODE].
f
The resolution and vertical scanning frequency settings may be required on your computer or video device.
f
After conguring settings, your computer or video device or the projector may be required to be restarted.
f
Output with resolution and vertical scanning frequency that have been set may not be performed depending on your computer or video
device.
f
When the image is displayed incorrectly even if the format is selected in [EDID MODE], please check the settings of [WIDE MODE]
(
x
page 84) or [SXGA MODE] (
x
page 84).
[HDMI IN]
Switch the setting when the external device is connected to the <HDMI 1 IN> terminal or the <HDMI 2 IN> terminal
of the projector and the image is not projected correctly.
1) Press as to select [HDMI IN].
2) Press the <ENTER> button.
f
The [HDMI IN] screen is displayed.
3) Press as to select [SIGNAL LEVEL].
4) Press qw to switch the item.
f
The items will switch each time you press the button.