Panasonic PT-LB75VU - Switching the Projector On;Off; Switching Off the Projector

Switching the projector on/off
Basic Operation
22 -
E
NGLISH
Switching off the projector
When operating the projector, check the status of the POWER indicator. (
Æ
page 20)
INPUT SELECT
RELEASE
POWER indicator
POWER LOCK indicator
(1), (2)
Press the POWER button.1 )
The conrmation screen will be displayed.
Without any operation for 10 seconds or press any button other than the
z
POWER button, the conrmation
screen will go off and return to the projection.
Press the POWER button again.2 )
The lamp goes off, the operational sound (beep) sounds, and projection stops.
The cooling fan continues its rotation and
z
POWER indicator lights in orange. Wait until the POWER LOCK
indicator and POWER indicator turn into red.
If
z
STANDBY MODE is set to NORMAL, the POWER indicator ashes in red. (
Æ
page 40)
You can set to
z
ON or OFF the beeping sound that occurs when the POWER button is in operation in
AUDIO SETTING.
(
Æ
page 41)
After the POWER LOCK indicator and POWER indicator light in red, disconnect the 3 )
power plug from the wall outlet. (
Æ
page 19)
For urgency, you may disconnect the power plug immediately since the
z
DIRECT POWER OFF function is
installed.
Remarks
Conrm that
z
CONTROL PANEL (when operating with the projector body) or REMOTE CONTROLLER (when
operating with the remote control) under CONTROL DEVICE SETUP in the SECURITY menu is set to ENABLE .
(
Æ
page 44)
You can switch off the power by pressing the
z
POWER button for 0.5 seconds or more.