Remote control operation
Basic Operation
26 -
E
NGLISH
Enlarging the image
You can enlarge the projected image down to a cen-
tered area for emphasizing within the range of 1× to 2×.
Press button.
Press the RETURN button to escape.
J
Button functions in digital zoom
mode
+ button: zooms in
-
button: zooms out
Press “
-
” Press “+”
Press ▲▼◄► to shift the center point.
Remarks
When the
z
COMPUTER signal is projected, the
enlargement range will be changed to 1× to 3×.
When FRAME LOCK in the POSITION menu is set
to ON, the enlargement range is 1× to 2×. However,
the enlargement range is 1× to 3× if FRAME LOCK
is set to OFF. (
Æ
page 34)
When the input signal is changed while the
z
DIGITAL ZOOM is activated, the DIGITAL ZOOM
mode will be cancelled.
While the
z
DIGITAL ZOOM is activated, the AUTO
SETUP, FREEZE, DEFAULT, INDEX-WINDOW
and FUNCTION (except when AV MUTE is
assigned) buttons are not available.
Using an assigned function
You can select a useful function from the list and
assign it to the FUNCTION button for a short-cut.
Press button.
Press the MENU button of the control 1 )
panel or remote control to display the
on screen menu (main menu, sub-
menu or detailed menu) .
For the menu operation, see “Navigating through
the MENU”. (
Æ
page 27)
Press and hold the FUNCTION button 2 )
of the control panel or remote control
for 3 seconds or more.
When not using the FUNCTION button
Q
Select DISABLE in this menu 1 )
(FUNCTION BUTTON in the
PROJECTOR SETUP menu).
Press the ENTER button.2 )
Select OK.3 )
Press the ENTER button.4 )
Remarks
For details, see “FUNCTION BUTTON” in the
z
“PROJECTOR SETUP menu”. (
Æ
page 41)
To Next Page
Loading...
