76 - ENGLISH
4) Press as to select an item, and change the setting according to the instructions.
[DHCP]
[On]:
If a DHCP server exists in the network to which the projector is connected,
the IP address will automatically be acquired.
[Off]:
If a DHCP server does not exist in the network to which the projector is
connected, additionally set [IP address], [Subnet] and [Gateway].
[IP address]
Enter the IP address if DHCP server is not used.
[Subnet]
Enter the subnet mask if DHCP server is not used.
[Gateway]
Enter the gateway address if DHCP server is not used.
[DNS]
Enter the DNS server address if DHCP server is not used.
5) Press as to select [Set], and press the <ENTER> button.
f The following settings are set before the projector leaves the factory.
[DHCP]
Off
[IP address]
192.168.1.100
[Subnet]
255.255.255.0
[Gateway]
192.168.1.1
[DNS]
192.168.1.1
Note
f Before using the DHCP server, make sure the DHCP server is already functioning.
f Consult your network administrator regarding the IP address, Subnet and Gateway.
[Network information]
1) Press as to select [Network].
2) Press the <ENTER> button.
f The [Network] screen is displayed and then conrm the following items.
[MAC address]
Displays the MAC address of this projector.
[IP address]
Displays the current IP address of this projector.
[SSID]
*1
Displays the SSID character string of the projector while the Wireless LAN is connected.
[Wireless IP]
*1
Displays the IP address of the wireless module which is inserted into the projector while the
wireless LAN is connected.
*1 It will be displayed when the wireless module (Model No.: ET-WML100) of the optional accessories is inserted.
[Remote control]
This switching function prevents remote control interference when operating several projectors or video equipment at the same
time.
1) Press as to select [Remote control].
2) Press the <ENTER> button.
f The [Remote control] screen is displayed.
3) Press as to select one item.
f This projector provides seven different remote control codes: [ALL], [Code 1]~[Code 6].
[ALL]
Select when controlling projectors without specifying an ID number.
[Code 1] - [Code 6]
Select when specifying an ID number to control individual projector.
4) Press the <ENTER> button.
f [Remote control] is set.
Note
f To specify an ID number for individual control, the ID number of a remote control must match the ID number of the projector.
f When the ID number is set to [ALL], the projector will operate regardless of the ID number specied by remote control. If
multiple projectors are set up side by side with ID set to [ALL], they cannot be controlled separately from the projectors with
other ID numbers.
f Refer to “Setting the remote control ID numbers” (x page 49) for how to set the ID number on the remote control.
Chapter 4 Settings - [Expand] menu
To Next Page
Loading...
