Panasonic PT-MZ670

Chapter 5 Operations — Projecting with MEMORY VIEWER input
186 - ENGLISH
Displaying the Memory Viewer screen
When the [NETWORK/USB] menu → [MEMORY VIEWER] → [AUTOPLAY] is set to [ON] or [OFF], the still image
or movie le can be selected and played back in the Memory Viewer screen.
When [AUTOPLAY] is set to [SCENARIO], the Memory Viewer screen is not displayed, and projection of still
image or movie and transmission of the Light ID signal are performed automatically following the setting of the
scenario le.
For operation of [SCENARIO], refer to “Playing back using the contents list” (x page 192).
1) Connect the USB memory with still image or movie file recorded to the <VIEWER/PAIRING> terminal.
f For the handling of the USB memory, refer to “Using the USB memory” (x page 69).
2) Press the <NETWORK/USB> button to switch the input to MEMORY VIEWER.
f Every time the <NETWORK/USB> button is pressed, the input will switch in the order of MEMORY
VIEWER, Panasonic APPLICATION, and MIRRORING. Press the <NETWORK/USB> button until the input
switches to MEMORY VIEWER.
f The Memory Viewer screen (thumbnail or list view) is displayed.
f The cursor is at the thumbnail display area or the list display area at the right of the screen. (Cursor
background color: yellow)
Example of displaying in thumbnail view Example of displaying in list view
Note
f Display method (displaying in thumbnail view or list view) in the Memory Viewer screen can be set in the [NETWORK/USB] menu →
[MEMORY VIEWER] → [VIEW] (x page 146).
Operating the Memory Viewer screen
This section describes an example of screen operations after the Memory Viewer screen is displayed.
For thumbnail view
1) Press asqw to select a file.
f Select a folder in the thumbnail display area and press the <ENTER> button to display the les inside that
folder.