Panasonic PT-MZ670

Chapter 3 Basic Operations — Switching on/off the projector
ENGLISH - 61
Initial setting (installation setting)
Set [FRONT/REAR] and [FLOOR/CEILING] in [PROJECTION METHOD] depending on the installation mode.
Refer to “Installation mode” (x page 35) for details.
After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu →
[PROJECTION METHOD].
1) Press qw to switch the setting.
2/6
ENTER
SET
CHANGE
Change the projection method (FRONT/REAR,
FLOOR/CEILING) if the screen display is upside down
or inverted.
PROJECTION METHOD
INITIAL SETTING
FRONT/REAR
FLOOR/CEILING
MENU SELECT
FRONT
AUTO
2) Press the <ENTER> button to proceed to the initial setting.
Initial setting (standby mode)
Set the operation mode during standby. The factory default setting is [NORMAL], which allows you to use the
network function during standby. To keep power consumption low during standby, set this item to [ECO].
After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu → [ECO
MANAGEMENT] → [STANDBY MODE].
1) Press qw to switch the setting.
3/6
When set to ECO, network functions and some RS-232C
commands are not available during standby.
INITIAL SETTING
SET
CHANGE
STANDBY MODE
NORMAL
ENTER
2) Press the <ENTER> button to proceed to the initial setting.
Note
f The preceding initial setting screen is displayed when the projector is switched on for the rst time after purchase. When the [PROJECTOR
SETUP] menu → [INITIALIZE] → [ALL USER DATA] is executed, the [STANDBY MODE] setting before executing is displayed.