Panasonic PT-RCQ10

Chapter 4 Settings — [PROJECTOR SETUP] menu
154 - ENGLISH
[SDI1 [SLOT]]
*2
Sets the secondary input to SDI1 of the Interface Board.
[SDI2 [SLOT]]
*2
Sets the secondary input to SDI2 of the Interface Board.
[SDI3 [SLOT]]
*2
Sets the secondary input to SDI3 of the Interface Board.
[SDI4 [SLOT]]
*2
Sets the secondary input to SDI4 of the Interface Board.
[DisplayPort1 [SLOT]]
*2
Sets the secondary input to DisplayPort1 of the Interface Board.
[DisplayPort2 [SLOT]]
*2
Sets the secondary input to DisplayPort2 of the Interface Board.
*1 Individual input on the twisted-pair-cable transmitter or the DIGITAL LINK output supported device cannot be specied.
*2 This can be selected when the optional Interface Board equipped with corresponding input is installed in the slot.
Note
f When the [PROJECTOR SETUP] menu → [NO SIGNAL SETTING] → [BACKUP INPUT SETTING] → [BACKUP INPUT MODE] is set to
anything other than [OFF], the secondary input switching function will not operate even when [SECONDARY INPUT] is set to anything other
than [OFF]. The backup input switching function is prioritized.
[BACK COLOR]
Set the display of the screen when a signal is not input.
1) Press as to select [NO SIGNAL SETTING].
2) Press the <ENTER> button.
f The [NO SIGNAL SETTING] screen is displayed.
3) Press as to select [BACK COLOR].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[BLUE] Displays blue in the entire screen.
[BLACK] Displays black in the entire screen.
[DEFAULT LOGO] Displays the Panasonic logo in the screen.
[USER LOGO] Displays the image registered by the user in the screen.
Note
f The [BACK COLOR] setting item is common with the following menu item.
g The [DISPLAY OPTION] menu → [BACK COLOR]
f To create and register the [USER LOGO] image, use “Logo Transfer Software”.
The software can be downloaded from the Panasonic website (https://panasonic.net/cns/projector/).
[NO SIGNAL LIGHTS-OUT]
This is a function to automatically turn off the light source of the projector when there is no input signal for specic
period. The time until the light source is turned off can be set.
1) Press as to select [NO SIGNAL SETTING].
2) Press the <ENTER> button.
f The [NO SIGNAL SETTING] screen is displayed.
3) Press as to select [NO SIGNAL LIGHTS-OUT].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[DISABLE] Disables the no signal lights-out function.
[10SEC.] - [5MIN.]
Turns off the light source when there is no input signal for the preset period.
Select [10SEC.], [20SEC.], [30SEC.], [1MIN.], [2MIN.], [3MIN.], or [5MIN.].
Note
f The fan will rotate to cool the projector while the no signal lights-out function is operating and the light source is turned off. Also, the power
indicator <ON (G)/STANDBY (R)> blinks slowly in green.
f When [NO SIGNAL LIGHTS-OUT] is set to anything other than [DISABLE], the following are the conditions to turn the light source back on
again from the condition that the light source has turned off by this function.
g When the signal has been input
g When on-screen display such as menu screen (OSD) or input guide, a test pattern, or a warning message is displayed