Chapter 4 Settings — [NETWORK] menu
ENGLISH - 177
[SIGNAL QUALITY]
[SIGNAL QUALITY] is a numerical value of the amount of error, and the display color changes to
green, yellow, or red depending on that value.
Check the signal quality level while receiving a signal from the twisted-pair-cable transmitter.
f [MAX]/[MIN]: Maximum/minimum value of the amount of error
f Green (
-
12 dB or lower) → normal signal quality level.
f Yellow (
-
11 to
-
8 dB) → caution level that noise may appear on the screen.
f Red (
-
7 dB or higher) → abnormal level with interrupted synchronization and receiving not
possible.
[WIRED LAN]
Perform the connection setting to use the wired LAN.
1) Press as to select [WIRED LAN].
2) Press the <ENTER> button.
f The [WIRED LAN] screen is displayed.
3) Press as to select an item, and change the settings according to the operation instructions of the
menu.
[DHCP]
[ON]
If a DHCP server exists in the network where the projector is to be
connected, obtains the IP address automatically.
[OFF]
If a DHCP server does not exist in the network where the projector
is to be connected, set [IP ADDRESS], [SUBNET MASK], and
[DEFAULT GATEWAY].
[IP ADDRESS] Enter the IP address when a DHCP server is not used.
[SUBNET MASK] Enter the subnet mask when a DHCP server is not used.
[DEFAULT GATEWAY] Enter the default gateway address when a DHCP server is not used.
4) Press as to select [STORE], and press the <ENTER> button.
5) When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
Note
f When using a DHCP server, conrm that the DHCP server is running.
f Consult your network administrator regarding the IP address, subnet mask, and default gateway.
f The network setting is common for the <LAN> terminal and the <DIGITAL LINK> terminal.
f When the [NETWORK] menu → [Art-Net SETUP] is set to [ON(2.X.X.X)] or [ON(10.X.X.X)], [WIRED LAN] cannot be selected.
f Wired LAN and wireless LAN cannot be used in the same segment.
[WIRELESS LAN]
Set the connection method of wireless LAN and its details.
f To use the wireless LAN function with the projector, it is necessary to attach the optional Wireless Module
(Model No.: AJ-WM50 Series) to the <USB> terminal.
1) Press as to select [WIRELESS LAN].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[ENABLE]
Select this item when the wireless LAN is to be used.
A device such as a smartphone can be directly connected to the projector even if a wireless LAN
access point is not set up separately because the projector is used as a simplied access point.
For setting procedure of the connection key, refer to “Setting the connection key” (x page 177).
[DISABLE] Select this item when the wireless LAN is not to be used.
Note
f [WIRELESS LAN] cannot be set if the optional Wireless Module (Model No.: AJ-WM50 Series) is not attached to the <USB> terminal.
f Maximum number of devices that can be connected simultaneously to the projector via wireless LAN is four devices.
Setting the connection key
1) Press as to select [WIRELESS LAN].
To Next Page
Loading...
