Panasonic PT-RCQ10

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 155
g When the power on <b> button is pressed
g When the operation to disable the shutter function (shutter: opened) is performed, such as pressing the <SHUTTER> button
g When the operating environment temperature is around 0 °C (32 °F) and the light source is forced to turn on due to warm-up
f The no signal lights-out function is disabled in following case.
g When [BACK COLOR] is set to [DEFAULT LOGO] or [USER LOGO], and the Panasonic logo or the image registered by the user is
displayed in the projected image
[NO SIGNAL SHUT-OFF]
This is a function to automatically set the power of the projector to standby mode when there is no input signal for
specic period. The time before switching to standby can be set.
1) Press as to select [NO SIGNAL SETTING].
2) Press the <ENTER> button.
f The [NO SIGNAL SETTING] screen is displayed.
3) Press as to select [NO SIGNAL SHUT-OFF].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[DISABLE] Disables the no signal shut-off function.
[10MIN.] - [90MIN.] Sets the time in increments of 10 minutes.
[INITIAL STARTUP]
Set the startup method when the <MAIN POWER> switch is set to <ON>.
1) Press as to select [INITIAL STARTUP].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[LAST MEMORY] Starts up the projector in the condition before the <MAIN POWER> switch is set to <OFF>.
[STANDBY] Starts up the projector in standby.
[ON] Starts projecting immediately.
[STARTUP INPUT SELECT]
Set the input when the projector is switched on to start projection.
1) Press as to select [STARTUP INPUT SELECT].
2) Press the <ENTER> button.
f The [STARTUP INPUT SELECT] screen is displayed.
3) Press asqw to select the input, and press the <ENTER> button.
[LAST USED] Keeps the input selected last.
[HDMI] Sets the input to HDMI.
[DVI-D] Sets the input to DVI-D.
[SDI] Sets the input to SDI.
[DIGITAL LINK] Sets the input to DIGITAL LINK.
[INPUT1] - [INPUT10]
*1
Sets the input to DIGITAL LINK, and switches the input of the Panasonic twisted-pair-cable
transmitter to the specied input.
[HDMI1 [SLOT]]
*2
Sets the input to HDMI1 of the Interface Board.
[HDMI2 [SLOT]]
*2
Sets the input to HDMI2 of the Interface Board.
[DVI-D1 [SLOT]]
*2
Sets the input to DVI-D1 of the Interface Board.
[DVI-D2 [SLOT]]
*2
Sets the input to DVI-D2 of the Interface Board.
[SDI1 [SLOT]]
*2
Sets the input to SDI1 of the Interface Board.
[SDI2 [SLOT]]
*2
Sets the input to SDI2 of the Interface Board.
[SDI3 [SLOT]]
*2
Sets the input to SDI3 of the Interface Board.
[SDI4 [SLOT]]
*2
Sets the input to SDI4 of the Interface Board.
[DisplayPort1 [SLOT]]
*2
Sets the input to DisplayPort1 of the Interface Board.