Chapter 1 Preparation — About your projector
34 - ENGLISH
Names and functions of the Interface Board (optional)
This projector is equipped with one SLOT NX-specication slot.
There are one HDMI input terminal, one DVI-D input terminal, one SDI input terminal, and one DIGITAL LINK
terminal equipped on this projector as the standard video input terminals. The input for HDMI, DVI-D, and SDI can
be added by installing the optional Interface Board in the slot.
r Interface Board for HDMI 2 input (Model No.: ET-MDNHM10)
This board supports the HDMI signal.
13 32
1 <HDMI IN 1> terminal
This is a terminal to input HDMI signal.
2 <HDMI IN 2> terminal
This is a terminal to input HDMI signal.
3 Handle
r Interface Board for DVI-D 2 input (Model No.: ET-MDNDV10)
This board supports the DVI-D signal.
13 32
1 <DVI-D IN 1> terminal
This is a terminal to input DVI-D signal.
2 <DVI-D IN 2> terminal
This is a terminal to input DVI-D signal.
3 Handle
r Interface Board for 12G-SDI (Model No.: ET-MDN12G10)
This board supports the HD-SDI signal, 3G-SDI signal, 6G-SDI signal, and 12G-SDI signal.
25 541 3
1 <SDI 1 IN> terminal
This is a terminal to input SDI signal
(HD-SDI/3G-SDI/6G-SDI/12G-SDI).
2 <SDI 2 IN/1 OUT> terminal
This is a terminal to input SDI signal (HD-SDI/3G-SDI).
This is also an active through terminal to output the SDI signal
(HD-SDI/3G-SDI/6G-SDI/12G-SDI) input to the <SDI 1 IN>
terminal of this board.
3 <SDI 3 IN> terminal
This is a terminal to input SDI signal
(HD-SDI/3G-SDI/6G-SDI/12G-SDI).
4 <SDI 4 IN/3 OUT> terminal
This is a terminal to input SDI signal (HD-SDI/3G-SDI).
This is also an active through terminal to output the SDI signal
(HD-SDI/3G-SDI/6G-SDI/12G-SDI) input to the <SDI 3 IN>
terminal of this board.
5 Handle
Note
f The <SDI 2 IN/1 OUT> terminal and the <SDI 4 IN/3 OUT> terminal do not support the input of the 6G-SDI signal or the 12G-SDI signal.
f To use the <SDI 2 IN/1 OUT> terminal or the <SDI 4 IN/3 OUT> terminal as an output terminal, set the [DISPLAY OPTION] menu → [SLOT
IN] → [SDI MODE] to [OUTPUT].
f When the projector is in standby mode, a signal is not output from the <SDI 2 IN/1 OUT> terminal and the <SDI 4 IN/3 OUT> terminal.
To Next Page
Loading...
