Panasonic PT-RCQ10 - Page 161

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 161
4) Press qw to switch the item.
f The items will switch each time you press the button.
[BNC] Uses the <MULTI PROJECTOR SYNC IN>/<MULTI PROJECTOR SYNC OUT> terminals (BNC).
[SERIAL] Uses the <SERIAL IN>/<SERIAL OUT> terminals.
Note
f [BNC] and [SERIAL] cannot be used simultaneously within the linked projectors.
[RS-232C]
Set the communication condition of the <SERIAL IN>/<SERIAL OUT> terminal. For details on the connection
method for RS-232C communication, refer to “<SERIAL IN>/<SERIAL OUT> terminal” (x page 241).
Setting the communication condition of the <SERIAL IN> terminal
1) Press as to select [RS-232C].
2) Press the <ENTER> button.
f The [RS-232C] screen is displayed.
3) Press as to select [INPUT SELECT].
4) Press qw to switch the item.
[PROJECTOR] Performs the RS-232C communication with the <SERIAL IN> terminal of the projector.
[DIGITAL LINK]
Performs the RS-232C communication via the optional DIGITAL LINK output supported device (Model
No.: ET-YFB100G, ET-YFB200G) and the <DIGITAL LINK> terminal.
5) Press as to select [(IN) BAUDRATE].
6) Press qw to switch the item.
f The items will switch each time you press the button.
[9600]
Select the proper speed.[19200]
[38400]
7) Press as to select [(IN) PARITY].
8) Press qw to switch the item.
f The items will switch each time you press the button.
[NONE]
Select the parity condition.[EVEN]
[ODD]
Setting the communication condition of the <SERIAL OUT> terminal
1) Press as to select [RS-232C].
2) Press the <ENTER> button.
f The [RS-232C] screen is displayed.
3) Press as to select [(OUT) BAUDRATE].
4) Press qw to switch the item.
[9600]
Select the proper speed.[19200]
[38400]
5) Press as to select [(OUT) PARITY].