Chapter 5 Operations — Updating the rmware
222 - ENGLISH
10) Confirm the firmware version.
f Update is completed when the light source indicators <LIGHT1>/<LIGHT2> stop blinking and turn off.
f Turn on the power of the projector and conrm the rmware version in the [STATUS] screen.
Attention
f Do not disconnect the main power supply of the projector while updating.
Note
f In following cases, turn the power of the projector off and on and perform the update from the beginning.
g When the update does not complete after 60 minutes or more have elapsed
g When the power of the projector has turned off due to power outage, etc., during the update
To Next Page
Loading...
