Panasonic PT-RCQ10 - Page 244

Chapter 7 Appendix — Technical information
244 - ENGLISH
Cable specication
1 NC NC 1
2 2
3 3
4 4
5 5
6 NC NC 6
7 7
8 8
9 NC NC 9
1 NC NC 1
2 2
3 3
4 4
5 5
6 NC NC 6
7 7
8 8
9 NC NC 9
When connected to a computer
Projector
(<SERIAL IN> terminal)
Computer
(DTE specifications)
When multiple projectors are connected
Projector 1
(<SERIAL OUT>
terminal)
Projector 2
(<SERIAL IN>
terminal)
Note
f The cable to be used for the contrast synchronization function and the shutter synchronization using the <SERIAL IN>/<SERIAL OUT>
terminal is required to be a cable with pins (4) connected to each other, such as full wired straight cable. Also, set the [PROJECTOR
SETUP] menu → [MULTI PROJECTOR SYNC] when using the contrast synchronization function or the shutter synchronization function.
Control command
The following table lists the commands that can be used to control the projector using a computer.
r Projector control command
Command Details
Parameter/response
string
Remark (parameter)
PON Power on
― To check if the power is on, use the “Power query” command.
POF Power standby
QPW Power query
000
001
STANDBY
Power on
IIS
Switching the input
signal
DVI DVI-D
HD1 HDMI
DL1 DIGITAL LINK
SD1 SDI
AU1,SD1
*1
SDI1 [SLOT]
AU1,SD2
*1
SDI2 [SLOT]
AU1,SD3
*2
SDI3 [SLOT]
AU1,SD4
*2
SDI4 [SLOT]
AU1,HD1
*1
HDMI1 [SLOT]
AU1,HD2
*1
HDMI2 [SLOT]
AU1,DV1
*1
DVI-D1 [SLOT]
AU1,DV2
*1
DVI-D2 [SLOT]
AU1,DP1
*1
DisplayPort1 [SLOT]
AU1,DP2
*1
DisplayPort2 [SLOT]
OSH Shutter control 0 OPEN
QSH Shutter status query 1 CLOSE
VSE Aspect ratio switch
0 DEFAULT
1 4:3
2 16:9
5 THROUGH
QSE
Aspect ratio settings
query
6 HV FIT
9 H FIT
10 V FIT
OCS Sub memory switch
01 - 96 Sub memory number
QSB
Sub memory status
query
*1 This can be used when the optional Interface Board equipped with corresponding input is installed in the slot.
*2 This can be used when the optional Interface Board for 12G-SDI (Model No.: ET-MDN12G10) is installed in the slot.